Workbench Series-6

Using some HDPE, I made two sliding pads for the twin screw vise to prevent vise jaw from dropping over the timeIMG_2335.JPG

IMG_2334.JPG

Tips from Lee Valley suggested to use a block with two dowels to accurately mark the inserted draw bolt end so I could drill the hole for the end cap. Instead of dowel, I used the drill bits, turned out to be very good tip. IMG_2333.JPG

IMG_2332.JPG
Finally, glued, draw pegged and assembled together. It was pretty excited moments.
IMG_2337.JPG

IMG_2336.JPG

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s